Model 5600 Econominder Control Valve Settings Overview

The Model 5600 Econominder water softener control valve is designed for efficient and cost-effective water softening operation. Proper settings configuration is crucial for optimal performance, salt efficiency, and consistent soft water delivery. The Econominder system features demand-initiated regeneration technology that adjusts regeneration cycles based on actual water usage, providing significant savings compared to timed regeneration systems when configured correctly.

Key Settings and Programming Parameters:

• Hardness Setting: Adjust based on local water hardness measured in grains per gallon
• Regeneration Time: Set preferred start time for regeneration cycles (typically 2:00 AM)
• Capacity Setting: Configure based on resin tank size and household water consumption
• Salt Dosage: Adjust salt usage per regeneration for efficiency and performance balance
• Regeneration Frequency: Days between regenerations or demand-based triggering
• Brine Refill Time: Control the amount of water entering the brine tank during refill

Initial Setup Procedure:

Begin by testing your water hardness to determine the correct hardness setting. Access the Econominder programming mode by pressing the designated program button. Set the current time and regeneration start time, typically programming regeneration for early morning hours when water usage is minimal. Configure the hardness setting according to your water test results, then set the capacity based on your system size and expected daily water usage. Finally, adjust the salt dosage setting to match your efficiency preferences and water hardness levels.